Window Well Repair Price Tool
Most calls we get about window wells start with “how much?” and the honest reply is that it depends on which of four jobs you have. A new well, a liner, a drainage rebuild, and a cover are priced very differently. This tool runs all four off the ranges on our pricing page.
Why water changes everything
The question that catches people off guard is the one about spring water. When a well fills and stays full, the steel is rarely the problem. The trouble is the stone bed underneath, and how well we rebuild that bed decides whether your new well is good for twenty-five years or gives out in five. Drainage is also the piece we cannot price from a photo, which is why we come out and measure at no charge.
Four checks you can do this weekend
- Look at how deep it goes. Measure from the lawn down to the bottom of the well. Anything past 46 inches needs a ladder.
- Test the metal where it meets the dirt. Poke it with a screwdriver. Firm steel under surface rust points to a liner; holes point to a new well. Our rusted well page lays out the whole check.
- Measure width and projection. For an egress well, code wants it at least as wide as the window and sticking out at least 36 inches from the wall.
- Watch it during a thaw. If water sits there for days, choose the drainage answer above. Our flooding well page explains why that is so common in this area.
When the window is the real issue
If the window inside the well is too small to count as a bedroom exit, fixing the well alone will not pass inspection. Our egress price estimator covers that bigger job. Otherwise, send this range to the quote form and we will schedule a measure with your scope already in hand.
How much should fixing my window well run?
Answer four things about the well outside your basement window. We pull every figure from the ranges posted on our pricing page, so the result matches what we would actually quote.
Our pricing page lists new wells at $1,000 to $3,000, liners at $400 to $900, drainage repair at $300 to $1,000, and covers at $150 to $600 apiece. Most jobs we see mix two or more of those, so the tool adds them together the same way.
Take this range to our quote formThis is a ballpark, not our quote. We can't judge drainage from a picture, and that is the main reason our measuring visit costs you nothing.
Frequently Asked Questions
My well is right under the bedroom window. Does it need a ladder?
When it serves an egress window and runs deeper than 46 inches, it does. Under Wisconsin UDC SPS 321.03(6)(e) there has to be a ladder or steps, with rungs no narrower than 12 inches, sticking out from the wall at least 3 inches, able to carry 200 pounds, and spaced 12 inches apart or closer.
When does a liner make sense instead of a new well?
Only when the old well can still hold back the soil. Push a screwdriver into the steel right at ground level: if it stays solid and the anchors are snug, a liner at $400 to $900 gets you years more at a small slice of replacement cost. If the tip goes through or the sides have bowed in, a liner would just cover up a well that is failing, and we will say that plainly.
Can you work on wells over the winter?
We can fit covers, but digging mostly waits. Wisconsin sets footings at least 48 inches deep for frost, and that is roughly how far down a well goes. Winter is a good time for us to measure and quote, then we excavate once the ground opens up, usually in April.
Why is the flooding answer such a big jump?
Because what we fix is under the well, not the well itself. Standing water almost always means the gravel column below has silted up or was never put in. We dig below the well, lay clean washed stone wrapped in fabric, and connect it to somewhere the water can go: the footing drain or a deep dry well. Skip that step and a brand new well floods just like the old one.
Green Bay Egress Windows